NOT FOR USE IN WOOD PANELED, CONCRETE OR HAND-PLASTERED WALLS. NOT FOR USE IN CEILINGS.
* When properly applied to walls constructed of standard one-half inch thick drywall or plasterboard, Thumbs Up! has been tested and shown to support up to 25lbs of weight. The amount of weight that will be supported by Thumbs Up! may be influenced by the condition of the drywall.

2.
Open the package and carefully remove the hangers. CAUTION: HANGERS ARE SHARP!

Figure 1

3.
Hold the hanger by the flat part of the head as shown in Fig. 1. Place the thumb and forefinger of the left hand on the square part of the head and the thumb and forefinger of the right hand on the round part of the head.

4.
Place the sharp point of the hanger where the wall has been marked as shown in Fig. 2. Firmly advance the point of the hanger through the wallboard surface rocking the hanger UP and DOWN as you advance the point into the wall.

Figure 2

If you cannot advance the hanger, you might be on a stud. Try moving the hanger at least 1.5” to the left or right of the original spot.

Figure 3

5.
Once the hanger is all the way into the wall rotate the hanger a quarter turn to the right so that the square part is up as in Fig. 3. You're now ready to hang your picture. HAPPY HANGING!